Average Reviews:
(More customer reviews)I thought I was going to have to throw out this blender since I couldn't find this part anywhere on Cuisinart's site, that is until I found it here on Amazon! This part took UNDER 5 minutes to replace.
Remove 3 screws on the bottom of the blender
Pull off cover
Use a screwdriver to keep the motor's shaft from spinning
On the other side, use a wrench, grab and unscrew the brass ring in a clockwise motion (It's reverse threaded)
Screw on new replacement blade driver (Counter-clockwise to tighten)
Put blender cover back on
Reinstall the 3 screws on the bottom of the blender
You're done!
I'm serious when I say that the whole process took me about 3 minutes.
REALLY beats having to buy a new blender.
Click Here to see more reviews about: Cuisinart SPB7-20TXN Blender Blade Driver Clutch
Click here for more information about Cuisinart SPB7-20TXN Blender Blade Driver Clutch
0 comments:
Post a Comment